How to Apply Hi-Float

Modified on Fri, 29 Jul, 2022 at 1:22 AM

ULTRA HI-FLOAT 16-oz.

Remove the cap and attach the pump. Turn it counterclockwise so the nozzle unlocks.
When using the pump for the first time– put a cup under the nozzle and keep pumping until the Hi-Float liquid comes out.
Slide the balloon onto the nozzle until the opening of the balloon reaches the base.
Use a full pump of Hi-Float for an 11-inch balloon. See the chart below for how much Hi-Float is needed for other-sized balloons.
Pinch the neck of the balloon while removing it and clean off the pump nozzle. Make sure Hi-Float does not get onto the neck of the balloon.
Elevate the opening while massaging the liquid into the balloon for a few seconds to spread the Hi-Float evenly. This will allow air to escape and prevent liquid from entering the neck of the balloon.
Inflate the balloon to a pear-shaped size and hand tie it. Balloons that are underinflated will not float upright, while fully inflated balloons will float straight up.

Balloon Size	Press Down Pump
9-inch	Half a pump
11-inch	1 pump
16-18-inch	2 pumps
24-26-inch	3 pumps

24-oz. and 96-oz. ULTRA HI-FLOAT

Attach the extension tube to the bottom of the pump. This tube is only for the 96-oz. bottle.
Tighten the threaded cap, after placing the pump on the bottle.
When using the pump for the first time– put a cup under the nozzle and keep pumping until the Hi-Float liquid comes out.
Choose the correct colored restriction clip based on balloon size. Refer to the table below.
Secure the restriction clip onto the neck of the pump dispenser.
Put the balloon on the nozzle until the opening reaches the base.
Pinch the neck of the balloon while removing it and clean off the pump nozzle. Make sure Hi-Float does not get onto the neck of the balloon.
Elevate the opening while massaging the liquid into the balloon for a few seconds to spread the Hi-Float evenly. This will allow air to escape and prevent liquid from entering the neck of the balloon.
Inflate the balloon to a pear-shaped size and hand tie it. Balloons that are underinflated will not float upright, while fully inflated balloons will float straight up.
When you are not using the bottle it is important to put the red cap on the pump outlet nozzle.

Balloon Size	ULTRA HI-FLOAT
9-inch	Purple clip
11-inch w/60/40 inflator	Purple clip
11-inch	Orange clip
14-inch	2 pumps orange
16-inch	2 pumps grey
24-inch	3 pumps grey
30-inch	2 pumps no clip
36-inch	3 pumps no clip
40-inch	4 pumps no clip
48-inch	3/4 cup (add through a funnel)
60-inch	1 1/2 cup (add through a funnel)

ULTRA Hi-Float takes a few hours to dry after inflation. It should be kept away from surfaces after inflation for the first few hours, as it is a sticky substance that may cause some damage. For the best safety practices, protective eyewear (glasses, goggles, etc.) is recommended when inflating balloons treated with Hi-Float.

Shop for Ultra Hi-Float 96OZ

Shop for Ultra Hi-Float 24OZ

Shop for ULTRA HI-FLOAT 473ml (16 oz.)

Shop for HI-FLOAT Dispenser

Please watch the video below for more information.